Configuring Intrusion Detection - HIKVISION DS-2CD2532F-I User Manual

User Manual of Network Camera

6.6.8 Configuring Intrusion Detection

Intrusion detection can set an area in the surveillance scene and once the area is been
entered, a set of alarm action is triggered.
Steps:
1. Check the Enable Intrusion Detection checkbox.
2. Click Draw Area, and then draw a rectangle on the image as a defense region.
Note: when you draw the rectangle, all lines should connect end to end to each
other. Up to four areas are supported.
You can click Clear to clear the areas you drawn.
The defense region parameters can be set separately.
3. Choose the region to be configured.
 Threshold: Range [0-10s], the threshold for the time of the object
loitering in the region. If you set the value as 0, alarm is triggered
immediately after the object entering the region.
 Sensitivity: Range [1-100]. The value of the sensitivity defines the size of
the object which can trigger the alarm, when the sensitivity is high, a very
small object can trigger the alarm.
 Percentage: Range [1-100]. Percentage defines the ratio of the in-region
Figure 6-47 Configuring Intrusion Area
76