Initial Connection; Administrator Access; Configure Ethernet Settings - Xerox Phaser 4622 System Administrator Manual

Machine Connection
Ethernet Port - 10/100/1000 Mbps
The machine is compatible with TCP/IP, SMB, LPD, AppleTalk, NetWare, IPP, HTTP, DHCP, LDAP, SNMP,
DNS and Port 9100. It supports an Ethernet connector as a standard feature, and wireless connectivity
as an option.

Initial Connection

Follow these steps to physically connect your machine to the network:
1. Connect the Power Cable
Ensure that the machine is connected to a suitable power supply and that the power cord is fully
plugged into the electrical outlet.
Connect the Ethernet Cable
2.
Connect a 10/100/1000 BaseT Ethernet cable to the Ethernet port on the left side of the machine
and the other end of the cable to your network port.
3. Power on the machine
The Power On button is located on the left side of the machine, to the left as you face the
machine.
4. Complete the Steps shown by the Installation Wizard
If this is the first time the machine has been powered on, the Installation Wizard will run.

Administrator Access

The Tools menu provides access to the Administrator Tools area. Administrator access is required to
change settings such as network information on the machine.
Press the Menu button on the Control Panel.
1.
2. Use the arrow buttons to select Tools. Press the OK button.
3. Enter the Administrator's Password. The default is 1111.
4. Press the OK button.

Configure Ethernet Settings

The Ethernet interface options available are:
1. Auto
2. 10 Mbps Full-Duplex
3. 100 Mbps Full-Duplex
4. 1000 Mbps Full-Duplex (Gigabit)
5. 10 Mbps Half-Duplex
6. 100 Mbps Half-Duplex
When Auto is selected, the machine detects the communication speed automatically and adjusts its
settings accordingly. In most cases Auto should be the Ethernet setting.
8 Phaser 4622
System Administrator Guide