Stomps - Kemper Profiling Amplifier Manual

12 KEMPER PROFILING AMPLIFIER

Stomps

The first section, labeled "STOMPS", is for your stomp box effects. This section offers four stomp box slots
which are represented by the four buttons labeled A, B, C, and D. Here you can place the built-in stomp
effects in any order and configuration you'd like. These effects are applied before the signal reaches the
STACK section.
Stomp LED color coding
♦
You'll notice that the stomp LEDs aren't simply lit green or not, but have many different colors. That's be-
cause these LEDs use color to help you identify which kind of algorithm is being used for each stomp.
Stomp algorithms are color coded like this:
Distortion
Wah
Chorus
Phaser & Flanger
Compressor
EQ
Delay
Effect Loop
You can change the algorithm for a stomp that is shown in the display by rotating the TYPE knob above
the left side of the display to scroll through the available algorithms. The BROWSE knob above the right
side of the display can be used to select items from lists of "local presets" that are available for every
stomp. Local presets are settings for a specific type of module (stomps and effects), stored independent
from the rig itself.
Red
Orange
Blue
Purple
Cyan
Yellow
Green
White