The Handle Assembly - Minelab Explorer II Manual

THE MINELAB EXPLORER II
www.minelab.com

THE HANDLE ASSEMBLY

The handle assembly is made up of the armrest, straps and the control box. It is
connected to the shaft assembly by the control box camlock.
Figure 2.10
24
THE HANDLE ASSEMBLY
Adjusting the armrest assembly
Figure 2.10
To adjust armrest:
STEP 1
STEP 2
P0268-C
Armrest adjustment
STEP 3
STEP 4
Loosen the screw in the center of the armrest (turn counter-
clockwise). Use a screwdriver or the edge of a coin.
Slide armrest to your desired position. Your hand should
comfortably grip the angled neck of the handle assembly,
with the detector feeling like an extension of your forearm.
Gently remove your arm.
Tighten screw (clockwise) to lock into position.