Reg-Rsp Registration Response; Ucc-Req Upstream Channel Change Request - Motorola SB5100 Series Installation Manual

Code Event Log Messages
I115.1 Guaranteed Min Up Stream Channel Bit
Rate configuration setting exceeds Max
Upstream Bit Rate.
I115.2 Guaranteed Min Up Stream Channel Bit
Rate configuration setting out of range
I116.0 Max Upstream Channel Transmit Burst
configuration setting invalid length
I116.1
Max Up Stream Channel Transmit Burst
configuration setting out of range
I117.0
Modem Capabilities configuration setting
invalid format.
I117.1
Modem Capabilities configuration setting.

REG-RSP Registration Response

Code Event Log Messages
I00.0
REG-RSP Registration Response
I01.0 Registration RSP invalid format or not
recognized
I02.0
Registration RSP not received.
I03.0
Registration RSP with bad SID.
I04.0
Service not available. Reason: Other
I04.1
Service not available. Reason:
Unrecognized configuration setting
I04.2
Service not available. Reason:
Temporarily unavailable
I04.3
Service not available. Reason: Permanent

UCC-REQ Upstream Channel Change Request

Code Event Log Messages
C00.0
UCC-REQ Upstream Channel Change
Request
C01.0
Async Msg received with invalid US
Channel ID length.
C02.0 UCC-REQ received unable to send UCC-
RSP, no TX opportunity.
Event Log Messages
Level Cable Modem Actions
4 (Error) Continue reading next bytes of Config
file. Set to Max
4 (Error) Continue reading next bytes of Config
file. Set to 0 value
4 (Error) Continue reading next bytes of Config
file. Set to 255
7 (Info) Continue reading next bytes of Config
file. Set to 0 value
7 (Info) No action taken
Level Cable Modem Actions
7 (Info) No action taken
4 (Error) Ignore it and continue reading next
bytes of REG-RSP msg
4 (Error) Reset the board.
4 (Error) Continue reading next bytes of REG-
RSP msg.
Level Cable Modem Actions
7 (Info) No action taken
4 (Error) CM will fix to correct length, continue
parsing the channel ID value, and send
UCC-RSP to CMTS.
SURFboard Cable Modem Installation Manual
B-5