Choosing The Installation Site - DeLonghi Pinguino CF 210 Use And Maintenance Manual

CHOOSING THE INSTALLATION SITE

Position the air conditioning unit on a flat sur-
face where the air outlet grilles cannot be
obstructed. Position the appliance at least 50
cm (19.7) away from walls or obstacles.
CABLE WINDER
Before installing the air exhaust hose, mount
the two cable winder brackets using the
screws supplied as shown in the figure.
Tools Required for Assembly:
A screwdriver to install cable winders on unit.
Assembly Time
Approximately 5 minutes
AIR EXHAUST ACCESSORIES
adapter
for flange
hose length
500 mm (19.7")
2000 mm (78.7")
adapter
I n s t a l l a t i o n
flange
crosspiece 675 mm
(26.5") - 1230 mm
(48.4") (some models
only)
INSTALLING THE AIR EXHAUST HOSE
1. Open out the end of the hose and screw the
two adapters on counterclockwise (see figure).
2. Fit the square adapter on the air exhaust hose
to the air exhaust outlet on the appliance.
3. Connect the other end (flange) to the neare-
st window.
Important: the air exhaust hose must be
between 500 mm (19.7") and 2000 mm
(78.7") long. You are recommended to keep
the air exhaust hose as short as possible.
During installation, keep the hose as horizontal
as possible without distorting it. Do not con-
nect the terminal to other exhaust ducts (flue
or chimney) as this could lead to malfunction.
square adapter
Flange
air exhaust
outlet
Correct wall installation: the hole must be
at a height of between 40 cm (15.7") and
130 cm (51.2") from the floor.
9