Troubleshooting - Fujitsu Siemens Computers SCENICVIEW A17-3A Operating Manual

SCENICVIEW A17-3A/A19-3A

Troubleshooting

In the event of a fault please check the following points. If this does not resolve the problem with the
display, the monitor should, if possible, be checked on another computer.
Please inform our Help Desk if you are unable to solve the problem.
Having this problem?
No screen display
(power indicator not lit)
No screen display
(power indicator lit)
Message:
No Signal
Message:
Frequency out of range:
## kHz / ## Hz
Please change the display mode
to 1280 x 1024 with 60 Hz
Picture position not correct
22
Check the following points:
► Check whether the power cable on the monitor is
connected correctly.
► Check whether the computer is switched on.
► Check whether the computer is switched on.
► Check whether the data cable for the monitor is
correctly attached to the monitor port on the
computer.
► Press any key on the computer keyboard - the
computer may be in energy saving mode.
► Alter the brightness and/or contrast until you get a
picture.
► Check that the data cable for the monitor is firmly
attached to the monitor port on the computer.
► Check whether the computer is switched on.
The input signal (horizontal frequency and refresh rate)
at the input shown does not correspond to the technical
specifications for the monitor.
► Adjust the video frequency range using the
computer software (see documentation for your
computer or your graphics card).
► Select a different screen resolution using the
computer software (see documentation for your
computer or your graphics card).
The monitor has detected a previously undefined mode.
► Adjust the monitor automatically (using the AUTO
button - if provided - or using the OSD menu).
► Set the picture position using the OSD menu.
A26361-K1159-Z120-1-7619, edition 1