Troubleshooting - Fujitsu Siemens Computers SCALEOVIEW Q22W-1 Operating Manual

Troubleshooting

Should an error occur, first check the following points. If the distortion is still not eliminated, the
monitor should, if possible, be checked on another computer.
If you are unable to solve the problem, please inform our help desk.
Having this problem?
No screen display
(power indicator does not light)
No screen display
(power indicator lights)
Message:
No Signal
Message:
Frequency out of range:
## kHz / ## Hz
Please change the display
mode to 1680 x 1050
60 Hz.
Message:
For best picture quality,
please change resolution to
1680 x 1050.
SELECT: Disable EXIT: Clear
A26361-K1213-Z120-1-7619, edition 1
Check the following points:
► Check whether the monitor is switched on.
► Check whether the power cable on the monitor is
connected correctly.
► Check whether the computer is switched on.
► Check whether the computer is switched on.
► Check whether the data cable for the monitor is
correctly attached to the monitor port on the computer.
► Press any key on the computer keyboard – the
computer may be in energy saving mode.
► Alter the brightness and/or contrast until you get a
picture.
► Check whether the data cable for the monitor is
correctly attached to the monitor port on the computer.
► Check whether the computer is switched on.
The input signal (horizontal frequency and refresh rate) at
the displayed input does not correspond to the technical
monitor data.
► Adjust the video frequency range using the computer
software (see documentation for your computer or
with
your graphics card).
► Set the resolution to 1680 x 1050 using the computer
software.
SCALEOVIEW H22-1W/Q22W-1
25