Sensor; Procedure 1Test Program Check; Procedure 2Replacement Check - Toshiba Satellite A100 Maintenance Manual

2.12 3D Sensor
2.12 3D Sensor
To check if the computer's 3D sensor is defective or malfunctioning, follow the
troubleshooting procedures below as instructed.
Procedure 1 Test Program Check
Procedure 2 Replacement Check
Procedure 1 Test Program Check
Execute the 3D sensor test program available as part of the maintenance test program. This
program checks the3D sensor. Insert the Bootable CD into the CD. Turn on the computer
and run the test. See Chapter 3 for information on how to perform the test.
If any error is detected by the test, go to Procedure 2
Procedure 2 Replacement Check
The 3D sensor chipset is mounted on the system board. If the 3D sensor malfunctions, the
system board might be faulty.
Disassemble the computer following the steps described in Chapter 4 and perform the
following checks:
Check 1 The system board may be faulty. Replace it with a new one following the
instructions in Chapter 4. Then go through procedure 1 again .
Satellite A100/A105 / TECRA A7 Maintenance Manual
2 Troubleshooting
2-25