Installing The Usb Board, Finger Print Board And Print Board - Toshiba Satellite A100 Maintenance Manual

4 Replacement Procedures

Installing the USB board, Finger Print Board and Print Board

Install the USB board, finger print board and print board according to the following
procedures and Figure 4-31.
Note: Be careful of the kill switch button for the USB board. It can be damaged when
installing the USB board. Make sure it is in the correct position.
1. Seat the print board in the correct position and connect the print SUMI-card to
CN5000 on the print board.
2. Secure the print board with one M2.5x3 flat-round-head screw.
3. Connect the finger print SUMI-card to CN6052 on the USB board.
4. Seat the finger print board in the correct position and connect the finger print SUMI-
card to CN23 on the print board.
5. Connect the USB SUMI-card to CN3000 on the USB board.
6. Seat the USB board in the correct position and connect the USB SUMI-card to CN26
on the system board.
7. Be sure the kill switch button is operational before proceeding.
4-50
4.12 System Board, USB board, AC-IN cable
Satellite A100/A105 / TECRA A7
Maintenance Manual