4.2 HDD
3. Remove the HDD pack by pulling on the cushion attached to the pack, following the
direction of the arrows.
NOTE: Do not disassemble the HDD pack when it is working normally. Disassemble
or replace the HDD pack only if it fails.
4. Place the HDD pack on a flat surface (such as a desk), and remove the two cushions.
CAUTION: Do not apply pressure to the top or bottom of the drive.
Satellite A100/A105 / TECRA A7
Figure 4-10 Removing the HDD pack
Figure 4-11 Removing the HDD cushion
Maintenance Manual
4 Replacement Procedures
4-23