3 DVSe Setup
This section contains important information on setting up the DVSe for
operation. Please read the entire section before performing any work.
3.1 Connecting by SCSI or 1394
Caution! The DVSe does NOT support the simultaneous use
of the SCSI and 1394 ports. Only connect one type of device at
a time.
SCSI
Connect a SCSI device to one of the two SCSI ports using the supplied SCSI
cable. Set the dip switches (SW1) on the back panel. Set SCSI Termination
and SCSI Power to On. Select SCSI as the type of Bus in the Setup Menu
under Bus Select.
Caution! Power must be shut down before connecting SCSI
cables between SCSI devices and the DVSe.
Dip Switches (SW1)
Set the Dip Switches to enable or
disable the features listed on the
illustration to the right. Switch
position up to turn off (disable), down
to turn on (enable).
1394 Firewire
Connect a 1394 device to one of the two 1394 ports using the supplied 1394
cable. Set the dip switches (SW1) on the back panel. Set SCSI Termination
and SCSI Power to OFF. Select 1394 as the type of Bus in the Setup Menu
under Bus Select.
Caution! Power must be shut down to all devices before
connecting 1394 cables between the 1394 device and the
DVSe.
0150-0178F
OFF
ON
1 2 3 4
13
1: SCSI TERMINATION
2: SCSI POWER
3: BUZZER
4: AUX
Kalatel DVSe