Configuring Master/Slave; Mounting The Hard Drives - GE Interlogix Kalatel DVSe Installation And User Manual

Motherboard Overview
Power
Supply
Load
Resistors
Jumpers
IDE IDE Power
Connectors Connectors

2.3 Configuring Master/Slave

Hard drives are connected in pairs to
IDE Connector #1 IDE Connector #3
each of the four IDE connectors. Each
pair of hard drives must be configured
IDE Connector #2 IDE Connector #4
as a Master and a Slave. Configure
the Master/Slave settings on each hard
drive individually using the jumpers
provided with the drive. Use the
diagram located on the hard drive to
determine the proper jumper
configuration.
If a single drive is connected to an IDE
connector, it must be configured as a
Master.

2.4 Mounting The Hard Drives

Remove the Hard Drive Support Bracket. This entails removing the screws at
either end and one screw from each installed hard drive.
Orient the hard drive so that the IDE Power Connector is near the bottom of the
chassis and facing the motherboard. Populate the drive array in order, starting
from the left.
Fasten the drive in place using the supplied screws. Fasten each drive using two
screws through the bottom of the chassis and one screw in the Hard Drive
Support Bracket.
Kalatel DVSe 10 0150-0178F