Table of Contents
Advertisement
V O L T A G E S E T T I N G S
It is essential that the voltage and frequency setting of your RoboColor III system
matches the mains supply. Otherwise damage may occur.
Warning!
Disconnect the fixture from AC power before removing any cover.
To change the controller vol tage sett ing
NEUTRAL.
Do NOT remove
BLUE wire.
1
Access the transformer by removing the top cover.
2
On the transformer, move the BROWN wire to the correct voltage terminal. If
the mains voltage is between 210 and 240 volt use the 230 volt tap. If the
voltage is between 240 and 255 volt then use the 250 volt tap.
3
Re-assemble the unit.
To change the head vol tage sett ing
1
Remove 6 screws from the back of the unit, as shown, and carefully withdraw
the entire rear assembly.
User Manual
230V
250V
First, remove
these 6 screws.
Service and Maintenance
Transformer
15
Advertisement
Table of Contents
