Converting The Bandsaw For Vertical Use; Adjusting The Blade Guide Bearings - Central Machinery 93507 Assembly And Operating Instructions Manual

Converting The Bandsaw For Vertical Use:

NOTE: Notching, slitting, and contour work is best
1.
done with the Bandsaw in its vertical position.
2. Raise the Saw Head to its full vertical position, mak-
ing sure it locks in position by turning the Hydraulic
Cylinder (20) to its "OFF" position. (See Figure
O.)
3. Remove the two Screws (141), and remove the Small
Vertical Cutting Plate (142). (See Figure P.)
4. Guide the Saw Blade (127) through the slot in the
Large Vertical Cutting Plate (182), and secure it in
position with the two Screws (141). (See Figure
P.)
SAW BLADE
(127)
SMALL VERTICAL CUTTING PLATE (142)
1. NOTE: Blade Guide Bearings (133) adjustment is a critical factor in the performance
of the Bandsaw.
2. It is always best to try a new Saw Blade (127) to see if it will correct poor cutting
before attempting to adjust the Blade Guide Bearings. For example, if a Saw Blade
becomes dull on one side sooner than the other, it will begin cutting crooked. A
Saw Blade replacement will correct this problem, whereas Blade Guide Bearings
adjustment will not.
3. If a new Saw Blade does not correct the problem, check the Blade Adjustable Seats
(134, 143) to obtain the proper clearance. (See Figure Q, next page.)
For technical questions, please call 1-800-444-3353.
SKU 93507
SCREWS (141)
FIGURE P

Adjusting The Blade Guide Bearings:

hYDRAULIC
CYLINDER
(20)
FIGURE O
LARGE
VERTICAL CUTTING PLATE
(182) SCREWS (141)
Page 17