Adjusting The Base; Adjusting The Knee Pad Height - Invacare RPS350-2 Owner's Operator And Maintenance Manual

Adjusting the Base

NOTE: For this procedure, refer to FIGURE 7.2.
1. Check that the legs are square when in the closed position.
2.
Place a square on the inside of the legs and base to determine the
3.
Adjust the linkage rods until

Adjusting the Knee Pad Height

NOTE: For this procedure, refer to FIGURE 7.3.
1. Pick a height setting that will be comfortable to the patient and provide the necessary
support.
NOTE: The knee pad should be positioned so that the knee portion of the leg contacts the pad.
2. Using both hands, pull both adjustment pins outward at the same time.
3. Position the knee pad to the desired height and release adjustment pins into the
corresponding alignment holes.
4. Check to make sure that both pins are engaged.
Part No. 1145811
90°
alignment is achieved.
Square
Linkage Rod
FIGURE 7.2 Adjusting the Base
Knee Pad
Adjustment Pin
FIGURE 7.3 Adjusting the Knee Pad Height
33
90°
alignment.
Linkage Rods
Adjustment Pin
Stand Up Lift Model RPS350-2
MAINTENANCE