Charging The Battery - Invacare RPS350-2 Owner's Operator And Maintenance Manual

OPERATING THE STAND UP LIFT

Charging the Battery

NOTE: For this procedure, refer to FIGURE 3.3.
NOTE: Invacare recommends the battery be recharged daily to prolong battery life.
NOTE: An audible alarm will sound (horn will beep) when battery is low.
1. Lift up on the handle on the back of the battery.
2. Lift the battery up and out of the control box.
CAUTION
Make sure there is an audible click when mounting the battery on the battery
charger to confirm proper mounting. Otherwise, injury or damage may occur.
3. Place the battery on the battery charger. Make sure there is an audible click.
NOTE: The charge LED will illuminate. When charging is complete, charge LED will stop
illuminating.
NOTE: A battery needing to be fully recharged will take approximately four hours.
4. Lift up on the handle on the back of the battery.
5. Lift the battery up and out of the battery charger.
6. Reinstall the battery onto the control box. Make sure there is an audible click.
Handle
Audible Click
Battery
Charger
Control
Battery
Box
NOTE: The battery
mounts to the control
box and battery
charger as shown.
FIGURE 3.3 Charging the Battery
20
Stand Up Lift Model RPS350-2 Part No. 1145811