Transferring To A Wheelchair - Invacare RPS350-2 Owner's Operator And Maintenance Manual

7. Instruct or assist the patient in lifting their feet off the footplate.
8. Remove the sling from around the patient.
9. Pull the stand up lift away from the commode.
10. When complete, recheck the sling for correct attachments.
11. To lift the patient from the commode, refer to Lifting the Patient starting on page 21.

Transferring to a Wheelchair

NOTE: For this procedure, refer to FIGURE 5.2 on page 28.
1. Ensure the legs of the lift with the patient in the sling are in the open position. Press
the legs open button until in maximum open position.
2. Move the wheelchair into position. Refer to Detail "A".
3. Engage the rear wheel locks of the wheelchair to prevent movement of the chair. Refer
to Detail "B".
DO NOT place the patient in the wheelchair if the locks are not engaged. The
wheelchair wheel locks MUST be in a locked position before lowering the patient
into the wheelchair for transport. Otherwise, injury may result.
4. Position the patient over the wheelchair.
5. Press the down arrow button and lower the patient into the wheelchair. Refer to
Detail "C".
Lock the rear swivel casters ONLY when positioning or removing the sling (standing
or transport) from around the patient. Otherwise, injury may occur.
6. Lock the rear swivel casters.
7. Unhook the sling from all attachment points on the stand up lift. Refer to Detail "D".
8. Instruct patient to lift their feet off the footplate. Assist the patient if necessary.
9. Remove the sling from around the patient.
10. Pull the stand up lift away from the wheelchair.
Part No. 1145811
TRANSFERRING THE PATIENT
WARNING
WARNING
27
Stand Up Lift Model RPS350-2