Connecting The Compressor To The Concentrator - Invacare HomeFill II Operator's Manual

4. Plug the opposite end of the power cord into the wall
outlet.
Wall
Outlet
Power
Cord
NOTE: This product has a polarized plug (one blade is wider than
the other). As a safety feature, this plug will fit in a polarized outlet
only one way. If the plug does not fit fully in the outlet, reverse the
plug. If it still does not fit, contact a qualified electrician. DO NOT
attempt to defeat this safety feature.
FIGURE 2.2 Installing the Power Cord

Connecting the Compressor to the Concentrator

NOTE: For this procedure, refer to FIGURE 2.3 on page 15.
1. Insert one end of the interconnect hose into the outlet
fitting on the back of the concentrator (Detail "A").
2. Insert the opposite end of the interconnect hose into the
inlet fitting on the side of the compressor (Detail "B").
NOTE: The metal tabs on the concentrator outlet fitting and the
compressor inlet fitting will pop out with an audible "click" when
the end of the interconnect hose is properly installed (Detail "C").
3. Loop any excess interconnect hose and secure to the back
of the concentrator with the fastening straps.
Part No 1100873
SECTION 2—INITIAL SETUP
Compressor
(REAR)
Electrical
Connection
14 HomeFill II Compressor
™