Transporting The Compressor; Installing The Power Cord - Invacare HomeFill II Operator's Manual

SECTION 2—INITIAL SETUP

Transporting the Compressor

NEVER transport a compressor with a cylinder connected
to or stored on the compressor, otherwise injury or
damage can occur.
When transporting the compressor, be careful not to
bump the compressor or the connectors into obstacles.
Otherwise, damage to the compressor may occur.
NOTE: For this procedure, refer to FIGURE 2.1.
1. There are two methods to
safely transport the
compressor:
A. One hand - Grasp the
hand grip at the
bottom rear of the
compressor.
B. Two hands - Grasp
the hand grips on the
sides of compressor.

Installing the Power Cord

NOTE: For this procedure, refer to FIGURE 2.2 on page 14.
1. Ensure the compressor is on a hard flat stable surface, such
as a table or the Ready Rack.
2. Make sure the power switch is in the Off (O) position
3. Plug the power cord into the electric connector in the back
of the compressor.
HomeFill II Compressor
™
WARNING
CAUTION
Hand Grip
Hand Grip
FIGURE 2.1 Transporting
13
Hand Grip
the Compressor
Part No 1100873