Care And Cleaning; Sealed Burner Assemblies - Hotpoint RGB501 Use And Care & Installation

Proper care and cleaning are important so your range
will give you efficient and satisfactory service. Follow
these directions carefully in caring for it to help assure
safe and proper maintenance.
CAUTION: DO NOT OPERATE THE BURNER WITHOUT ALL BURNER PARTS AND DRIP PANS
(IF SO EQUIPPED) IN PLACE.

Sealed Burner Assemblies

Turn all controls OFF before removing the
burner parts and drip pans (if so equipped).
The burner grates, caps, burner heads and drip
pans (if so equipped) can be lifted off, making them
easy to clean.
The electrode of
the spark igniter is
exposed when the
burner head is
removed. When one
burner is turned to LITE, all the burners spark.
Do not attempt to disassemble or clean around
any burner while another burner is on. An electric
shock may result, which could cause you to knock
over hot cookware.
Burner Caps
(on sealed burners only)
Lift off when cool. Wash burner caps
in hot, soapy water and rinse with
clean water. You may scour with a
plastic scouring pad to remove
burned-on food particles.
Dry them in a warm oven or with a
cloth—don't reassemble them wet.
Replace the burner caps.
Make sure that caps are replaced on
the correct size burner. There is one
small, 2 medium and one large cap.

CARE AND CLEANING

(on some models)
Grate
Burner cap
Drip pan
(on some models)
Burner head
Electrode
Electrode
small
medium
large
NOTE: On some models the caps
are all the same size and can be
used in any of the 4 needed
locations.
BE SURE ELECTRICAL POWER IS
DISCONNECTED BEFORE CLEANING ANY
PART OF YOUR RANGE.
Burner Heads
(on sealed burners only)
For proper ignition, make sure the small hole in
the section that fits over the electrode is kept open. A
sewing needle or wire twist-tie works well to unclog it.
The slits in the burner heads of your range
must be kept clean at all times for an even,
unhampered flame.
You should clean the surface burners routinely,
especially after bad spillovers, which could clog
these openings.
To remove burned-on food, soak the burner heads in a
solution of mild liquid detergent and hot water for 20-
30 minutes. For more stubborn stains, use a toothbrush.
Before putting the burner head back, shake out
excess water and then dry it thoroughly by setting
it in a warm oven for 30 minutes.
Replace the burner caps. Make sure that caps are
replaced on the correct size burner. There is one
small, 2 medium and one large cap.
NOTE: On some models the caps are all the same
size and can be used in any of the 4 needed locations.
medium
medium
small
large
Front of Range
(continued next page)
23