Searching For Codes; Dentifying Odes Found Using; Earch; Rocedure - X10 PUR08 Owner's Manual

S F C
EARCHING OR ODES
1. Turn on the device
you want to
control.
2. Press and hold
SETUP until the
LED indicator
lights steadily.
Release Setup
button.
3. Press the mode
button that
matches the
equipment you
want to control.
The LED blinks
once. For Aux,
press Aux, then the
mode button.
4. Press CH +
repeatedly* until
the device to be
controlled
changes channel.
If you go past the
code accidentally,
just press LAST
repeatedly until the
channel changes
again.
5. Press and release
the ENTER button
to complete the
setup.
*Note: You may have to press CH + *Note:
many times (50+). If the device does not
have a Channel Up function, use the PLAY
button (VCR only) or the POWER button.
26
I C
DENTIFYING ODES FOUND USING THE
S P

EARCH

ROCEDURE

1. Press and hold
SETUP until the
LED indicator
lights steadily.
Release Setup
button.
2. Press the mode
button that
matches the
equipment you
want to identify The
LED blinks once.
For Aux, press Aux,
then the mode
button.
3. Press and release
SETUP. The LED
blinks once.
4. To find the first
digit, press each
number button
from 0 to 9 until the
LED blinks. The
number you
pressed is the first
digit of the code.
5. Press each
number button
from 0 to 9 again
as above to find
the second digit.
6. Press each
number button in
turn to find the
third digit. When
the third digit has
been found, the
LED will go out.
27