Installing The Components; Transceiver Module; Lamp Module - X10 PUR08 Owner's Manual

I
NSTALLING THE
C
OMPONENTS
T M
RANSCEIVER ODULE
The Transceiver Module receives radio
frequency (RF) commands from remotes to
operate a lamp or appliance plugged into
it. The Transceiver Module also passes on
commands over your house wiring to
control other X-10 modules. Note that
unlike the Lamp Module you cannot dim
and brighten a lamp connected to the

Transceiver Module.

You should locate the Transceiver Module
centrally in the home for maximum range
when controlled by the Learning Remote.
1. Set the House
Code to 'A' .
2. Plug a lamp or
appliance into the
Transceiver
Module.
3. Plug the
Transceiver
Module into a
convenient AC
outlet. Fully extend
the antenna.
L M
AMP ODULE
The Lamp Module may be used to control
any incandescent lamp rated up to 300W. It
is not suitable for other types of lamps such
as fluorescent or energy saving lamps, or
lamps which include a dimmer control.
Caution: Do not connect an appliance Caution:
such as a coffee pot or heater to the Lamp
Module. It may damage the module and the
appliance and could cause a fire hazard.
8
1. Set the House
Code to 'A' and the
Unit Code to '2.'
2. Plug a lamp into
the Lamp Module.
3. Plug the Lamp
Module into a
convenient AC
outlet.
8- -1 L R
IN EARNING EMOTE
The 8-in-1 Learning Remote allows you to
control practically everything electrical in
your home. It combines IR technology that
lets you control all your TV, VCR, Cable
and Satellite equipment with X-10 RF
technology that lets you control lamps and
appliances anywhere in your home.
To find out more about configuring the
Learning Remote to work with your audio/
video equipment, see the section titled
"Setting Up Your Remote."
1. Push the tab and
lift off the battery
cover.
2. Fit four AAA
batteries, taking
care to match the +
and - marks in the
battery
compartment.
9