Searching For Codes; Identifying Codes Found Using; The Search Procedure - X10 SUPERREMOTE UR47A Owner's Manual

Notes:
If your audio/video component does
not respond, try the other codes for your
brand. If it still doesn't respond, try the
Code Search method below.
If the LED blinked rapidly when you
entered the code, you may have entered
an invalid code. Recheck the code in the
code list and try again.
S F C
EARCHING OR ODES
1. Turn on the device
you want to control.
2. Press and hold
SETUP until the LED
indicator lights
steadily. Release
Setup button.
3. Press the mode
button* that
matches the
equipment you
want to control.
The LED blinks
once.
4. Press CHANNEL +
repeatedly* until
the device to be
controlled changes
channel.
If you go past the
code accidentally,
just press
CHANNEL -
repeatedly until the
channel changes
again.
5. Press and release
the ENTER button to
complete the setup.
14
*Note: You might have to press
CHANNEL + many times (50+). If the
device does not have a Channel Up
function, use the PLAY button (VCR and
DVD only) or the POWER button.
* When searching for, or identifying
codes stored under AUX, press AUX
before pressing the mode key.
I C
DENTIFYING ODES FOUND USING
S P
THE EARCH ROCEDURE
1. Press and hold the
SETUP until the LED
indicator lights
steadily. Release
Setup button.
2. Press the mode
button* that
matches the
equipment you wish
to identify. The LED
blinks once.
3. Press and release
SETUP. The LED
blinks once.
4. To find the first
digit, press each
number button from
0 to 9 until the LED
blinks. The number
you pressed is the
first digit of the
code.
5. Press each number
button from 0 to 9
again as above to
find the second
digit.
6. Press each number
button in turn to
find the third digit.
When the third
digit has been
found, the LED will
turn off.
15