Controlling X-10 Pro Modules; Hanging The X-10 Pro - X10 PUR08 Owner's Manual

C X-10 P
ONTROLLING
M
ODULES
If you have already installed a PAT01
Transceiver Module, (sold separately) you
can control it and other X-10 Pro modules
as follows:
1. Press and release
the X-10 button.
2. Use the number
buttons to enter the
Unit Code number
of the chosen
module. (You do
not need to enter
'0' first for a single
digit number.)
3. Press the appro-
priate button for
the function you
require (see
below).
X X -10 PRO FUNCTIONS: -10 PRO FUNCTIONS:
On:
Off:
Bright:
Dim:
All Lights On:
All Modules Off:
Note: You cannot dim or brighten an Note:
Appliance Module. If the module was off
and you press Bright or Dim (VOLUME+
or VOLUME-) this will simply turn the
module on.
T X-10 S
O SET THE LEEP
The X-10 Sleep Timer switches off the
chosen modules after the preset time.
1. Press and release
the X-10 button.
32
RO
2. Press and hold
3. Use the number
4. Press the desired
5. Using the number
6. Press ENTER to
CHANNEL +
CHANNEL –
VOLUME +
VOLUME – C
POWER
C
MUTE
The Learning Remote defaults to House
Code A, and in most cases you will not
need to change this unless you are
experiencing interference from a
neighboring X-10 system.
T
IMER 1. Press and release
TIMER until the
LED indicator
lights steadily.
Release TIMER
button.
buttons to enter the
module Unit Code
for the module to
be turned off.
function button
(e.g. CH - to turn
the module off
after the preset
time).
buttons enter the
sleep time
required (1 to 99
mins).
confirm the setting.
X-10 P
HANGING THE RO
:
ODE
the X-10 button.
33
H
OUSE