Connecting To A Computer - Eiki LC-WB42N Owner's Manual

Connecting to a Computer
Cables used for connection
• VGA cables (Mini D-sub 15 pin) *
• USB cable
• Audio cables
• HDMI-DVI cable
(*One cable is supplied; other cables are not supplied with the projector.)
Audio Output
USB cable
Audio cable
(stereo)
USB
COMPUTER 1 COMPONENT/
COMPUTER 2 AUDIO IN
Note:
• Input sound to the COMPUTER1 COMPONENT/COMPUTER
2 AUDIO IN terminal when using the COMPUTER IN 1/
COMPONENT IN and the COMPUTER IN 2/MONITOR OUT
terminal as input.
• When the AUDIO OUT is plugged-in, the projector's built-in
speaker is not available.
• USB cable connection is needed when operating the computer
with the remote control or using the PAGE ▲▼ buttons on the
remote control.
• When the cable is of the longer variety, it is advisable to
use the COMPUTER IN 1 / COMPONENT IN and not the
COMPUTER IN 2.
Monitor Monitor Output /
Output Monitor Input
VGA VGA
cable cable
COMPUTER IN 1 COMPUTER IN 2 /
COMPONENT MONITOR OUT
This terminal is
switchable. Set up
the terminal as
COMPUTER IN 2 or
MONITOR OUT.(See
Page 53.)
DVI
Output
External Audio Equipment
HDMI-DVI
cable
HDMI
AUDIO OUT
(stereo)
Note:
• Analog RGB and component signals cannot be
output from the COMPUTER IN 2/MONITOR
OUT terminal when using the COMPUTER IN
2/MONITOR OUT terminal as output.
• When DVI signal is connected to HDMI terminal
with HDMI-DVI cable, connect the sound signal
to COMPUTER 2 AUDIO IN and set up Sound of
"HDMI setup" to "Computer2". (p.53)
Unplug the power cords of both the
projector and external equipment
from the AC outlet before connecting
cables.
Installation
Audio Input
Audio cable
(stereo)
17