Power Wheels Kawaaki Super Shock 73600 Owner's Manual And Assembly Instructions page 13

12
Upper Shock Rod
Upper Hole
See
Inset
Upper
Shock
Rod
Top View
Assembly
Right Side View
• Slide the upper shock
rod through the upper
hole in the vehicle frame,
through the upper portion
of the monoshock and out
through the other side of
the vehicle frame.
Hint: You may want to
hold the monoshock in
position to fit the upper
shock rod through it.
13
.437 Cap Nut
Left Side View
• Fit a .437 cap nut on the other end of the upper shock rod.
• Tap the cap nut with a hammer to secure the cap nut on
the upper shock rod. Pull on the cap nut to be sure it
is secure.
Hint: You may need the help of another adult to support
the other end of the upper shock rod.
14
• Place the right rear fender on the side of the vehicle
frame, as shown.
• Insert four #8 x 3 / " screws through the right rear fender
4
and into the vehicle frame.
*Note: The most forward screw should insert into the
fender, through the footboard and then into the
vehicle frame.
• Tighten the screws with a Phillips screwdriver.
Do not over-tighten.
• Repeat this procedure to to attach the left rear fender to
13
the vehicle frame.
End of Upper
Shock Rod
.437 Cap Nut
.437"
Right Rear
Fender
Right Side View
*