Panasonic DP-3010 Service Handbook page 100

4.1.7. F8 Mode: Service Adjustment
Set the machine to Service Mode and press "8" key on the Keypad.
↓
Press the "START" key.
↓
Select the desired code number on the Touch Panel display.
↓
If you wish to select another code number, scroll the menu with the arrow buttons.
↓
Select the desired function on the Touch Panel display and touch the "OK" button.
↓
When the "C (CLEAR)" key is touched, the selected code input will not be accepted.
↓
Press "FUNCTION" and "C (CLEAR)" keys simultaneously to exit the service mode.
No.
00 Exp. Lamp replacement
01-05 Not Used
06 Error Log Print/View
07 Error Log Clear
08 (Factory use only)
09 Toner Density adjustment
10 Drum Charge adjustment
11 Not Used
12 Org.size Sensor Adj.
13 Black Density reference
14 Black Density gain
15 QUANTUM Pattern
16-17 Not Used
18 LSU PWM Pattern
Ver.2.0
F8 Mode
Item
When replacing the exposure lamp.
Procedure:
a) Press the Start key to move the exposure lamp to
the position (approx. 250 mm from the optics
home position) where it can be replaced.
b) To return the optical system to the home position,
press the CLEAR key.*
a) Each time the arrow key is pressed, the machine
errors or paper jam codes stored in memory are
displayed, beginning with the oldest code.
Note:
Only the 30 most recent codes are displayed.
a) Press the Reset key.
A Message "Error code can be cleared with the
Start key" is displayed on the LCD.*
b) Press the Start key.
Lock operation for Scanner Unit.
Adjustment operation of Toner Density.
Adjustment operation of Drum Charge.
Adjust the slice level for the original size detection
sensors automatically. Execute this mode by closing
the platen cover.
Adjustment operation of Black Density sensor.
Adjustment operation of Black Density sensor gain.
Print out the QUANTUM Test Pattern.
Print out the Test Pattern.
Proceed when the LSU is replaced.
100
DP-2310/3010
DP-2330/3030
Remarks
DEC 2004