Assembly - Char-Broil Professional Series 463233503 Assembly, Use And Care Manual

Assembly - 463233503

• Unpack and remove all protective packaging.
1. Position bottom shelf with the tank hole toward the left side.
See Fig. 1.
VERY IMPORTANT:
indicate their assembly position to the bottom shelf. LF
Front, LR LR=Left Rear, RF LR LR LR RF RF RF=Right Front, and RR RF
Rear. Labels should face inward toward each other when
correctly assembled. Remaining components cannot be
assembled if leg positions are incorrect.
2. Install the four cart legs to the indicated corners of the
bottom shelf using 8 of the 1/4x2-1/2" Phillips-head screws
provided. Do not fully tighten screws.
3. Install bowl support brackets, facing inward, to cart legs on
both sides using 8 of the 1/4x1/2" Phillips-head screws.
Fully tighten. See Fig. 1.
FIGURE 1
Bowl
Support
Bracket
LR
LF
Tank Hole
6 • 463233503
The labels on the cart legs
LF=Left LF LF LF
RR=Right RR RR RR
Bottom
Shelf
RF
4. Screw the 4 casters into the caster seats in the bottom of
each cart leg. Turn the threaded caster stem by hand,
clockwise until it stops. Fully tighten with the wrench
provided. See Fig. 2.
5. Install the two side panels and one rear panel to the cart by
using 4 of the 3/16x1/2" Phillips-head screws on each
panel. Leave rear panel screws loose. See Fig. 2.
FIGURE 2
Side
panel
6. Attach the door bracket to the lower holes in the front legs
with the end tabs pointing upward and the flange to the rear,
pointing downward. Use 2 of the 1/4x1/2" Phillips-head
screws. Do not fully tighten. See Fig. 3.
7. Attach the door stop to the bottom shelf, with the flange
facing the front , using 2 of the 3/16x3/8" Phillips head
screws. Fully tighten. See Fig. 3.
8. Place doors into the hinge holes of the bottom shelf and
RR
door bracket. Push door bracket down until doors are
secure and can open and close freely. Do not fully tighten
door bracket screws. See Fig. 3.
9. Remove protective film from doors. Install door handles to
doors using 4 of the 3/16x3/8" Phillips-head screws and
washers. See Fig. 3.
10. Attach the 4 side shelf brackets to the tops of the cart legs
using 8 of the 1/4x1/2" Phillips-head screws. Be sure the
flat side of each bracket faces outward. Fully tighten.
See Fig. 3.
FIGURE 3 ON NEXT PAGE
Caster
Rear
panel
Side
panel