Dmx Channel Values In-Depth; Troubleshooting - Blizzard Lighting Snowblind FX Manual

DMX Values In-Depth (6-Channel Mode)
Ch. Value
1 000 <--> 255
2 000 <--> 255
3 000 <--> 255
4 000 <--> 255
5 000 <--> 255
000 <--> 069
070 <--> 104
105 <--> 139
6 140 <--> 174
175 <--> 209
210 <--> 244
245 <--> 255

Troubleshooting

Symptom
Fixture Auto-
Shut Off
Beam is Dim
No Light Out-
put
Chase Speed
Too Fast/Slow
No Power
Blown Fuse
Slow Move-
ment
No Response
to Audio
Fixture Not
Responding /
Responding
Erraticly
Intermittant
Lamp
SnowBlind™ FX Manual - Rev. B
What It Does
LED 1 Intensity (0% <--> 100%)
LED 2 Intensity (0% <--> 100%)
LED 3 Intensity (0% <--> 100%)
LED 4 Intensity (0% <--> 100%)
Flash (Slow <--> Fast)
Static Color & Strobe
Program 1 (Channel 1 Controls Speed)
Program 2 (Channel 1 Controls Speed)
Program 3 (Channel 1 Controls Speed)
Program 4 (Channel 1 Controls Speed)
Sound Active Mode 1
Sound Active Mode 2
Solution
Check the fan in the fixture. If it is stopped or moving slower
than normal, the unit may have shut itself off due to high
heat. This is to protect the fixture from overheating. Clear
the fan of obstructions, or return the unit for service.
Check optical system and clean excess dust/grime. Also
ensure that the 220V/110V switch is in the correct position, if
applicable.
Check to ensure fixture is operating under correct mode, IE
sound active/auto/DMX/Etc., if applicable.
Check to ensure proper setup of speed adjustment.
Check fuse, AC cord and circuit for malfunction.
Check AC cord and circuit for damage, verify that moving parts
are not restricted and that unit's ventilation is not obstructed
Verify that 220V/110V switch is in the correct position, if ap-
plicable. Also check that speed channels are set appropriately.
Verify that the fixture is in "Sound Active" mode.
Adjust Audio Sensitivity, If Applicable.
Make sure all connectors are seated properly and securely.
Use Only DMX Cables and/or check cables for defects
Install a Terminator.
Reset fixture(s).
Check lamp for properly installation.
Relamp, lamp may have reached end of life.
Page 13
Copyright (c) 2013 Blizzard Lighting, LLC