Daily Checks; Weekly Checks - Pride Jazzy 1120 Owner's Manual

X . C A R E
n Make sure the drive tires are inflated to 30 – 35 psi. See figure 46.
WARNING! Make sure your tires are inflated to 30-35 psi. Do not underinflate or overinflate your
tires. Low pressure may result in loss of control, and overinflated tires may burst. Serious personal
injury may result. Overinflating tires can cause them to explode and can result in personal injury.
WARNING! Do not use a high pressure hose to inflate your tires.
n Use a rubber conditioner on the tire sidewalls to help preserve them. Never use a rubber conditioner on the
tread area of the tires; doing so may make the tires slippery and cause your Jazzy to skid. Check for wear.
WARNING! Never use a rubber conditioner on the tread area of the tires; doing so may make the
tires slippery and cause your power chair to skid.
n The body shroud has been sprayed with a clear sealant coating. You can apply a light coat of car wax to help
it retain its high-gloss appearance.
n Check all electrical connections. Make sure they are tight and are not corroded. Batteries must sit flat within
the battery well, with the battery terminals facing inward, toward each other. Refer to the frame decal for the
correct wiring layout.
n All wheel bearings are prelubricated and sealed. They require no subsequent lubrication.

DAILY CHECKS

n With the controller turned off, check the joystick. Make sure it is not bent or damaged and that it returns to the
center when you release it. Check the rubber boot around the base of the joystick for damage. Visually inspect
the boot. Do not handle or try to repair it. See your authorized Pride provider if there is a problem.
n Visually inspect the controller harnesses. Make sure that they are not frayed or cut or have any wires exposed.
See your authorized Pride provider if there is a problem with any of these harnesses.

WEEKLY CHECKS

n Disconnect and inspect the controller and the charger harnesses from the utility tray. Look for corrosion.
Contact your authorized Pride provider if necessary.
n Ensure that all parts of the controller system are securely fastened to your Jazzy. Do not overtighten any screws.
n Check for proper tire inflation. There should be 30 – 35 psi in each tire. If a tire does not hold air, see an
authorized Pride provider for replacement of the tube.
n Calibrate the joystick if a noticeable difference in performance is detected or if the joystick does not operate
properly. You can do this for the Remote Plus, Pilot, and Europa controllers.
n Check the brakes. This test should be carried out on a level surface with at least three feet of clearance around
your Jazzy.
To check the brakes:
1. Turn on the controller and turn down the speed and response adjustment knob.
2. After one second, check the battery gauge. Make sure that it remains on.
3. Slowly push the joystick forward until you hear the electric brakes click. Immediately release the joystick. You
must be able to hear each electrical brake operating within a few seconds of joystick movement. Repeat this
test three times, pushing the joystick backwards, then left, and then right.
Jazzy 1120/RevE/Feb03
A N D M A I N T E N A N C E
www.pridemobility.com 47