Pride Jazzy 1120 Owner's Manual page 29

V I . C O M F O R T
NOTE : Each drive tire must have at least 30 lbs. of air pressure in order for the anti-tip wheels to be
properly adjusted.
SEAT REMOVAL
You may wish to remove the seat for transportation. If you have a
Versa Seat, please refer to the Versa Seat Installation and Adjustment
guide.
To remove the seat:
1. Turn the power off.
2. Make sure your Jazzy is not in freewheel mode.
3. Unplug the main wire harness from behind the seat.
4. Simultaneously depress the two plungers on the front of the seat
frame while lifting the front of the seat. See figure 32.
5. Lift the seat up and gently lower it back onto the front seat towers.
6. Pull the seat forward and lift it off of the rear seat towers.
To remove a power seat:
1. Push down on the seat release lever.
2. Lift the seat off of the actuator.
BODY SHROUD REMOVAL
The body shroud is a one-piece, molded plastic body that covers the
power base frame. It helps protect the Jazzy components from the
environment. It also provides mounting points for lights and the stan-
dard light switch. You must remove the body shroud in order to change
the batteries and check the cable connections.
To remove the body shroud:
1. Turn the power off.
2. Make sure your Jazzy is not in freewheel mode. See IV. “The
Jazzy 1120.”
3. Unplug the controller wiring harness.
4. Remove the seat.
5. Disconnect the lighting harness (if your Jazzy is equipped with lights).
6. Lift the body shroud straight up. The body shroud is attached to
the metal frame by reusable fasteners. The body shroud should lift
up easily.
Jazzy 1120/RevE/Feb03
A D J U S T M E N T S
Figure 30. Anti-Tip Wheel Adjustment
Figure 31. Anti-Tip Wheel Adjustment
www.pridemobility.com 29