Pride Jazzy 1120 Owner's Manual page 18

I V .
UTILITY TRAY
The utility tray is located on the rear of your Jazzy. See figure 2c. A section of the utility tray is exposed through
the body shroud. The rest of the utility tray is located underneath the rear door. The utility tray consists of the
ammeter, the battery charger cord, the main circuit breaker, the light connectors (optional equipment), and the
controller harness connectors. See figures 2c through 6.
n Ammeter: The ammeter displays the charger’s current output in amps. See figure 2c. For more information,
see IX. “Batteries and Charging.”
n Battery Charger Cord: This cord is used whenever your battery needs recharging. See figure 2c.
n Main Circuit Breaker: The main circuit breaker is a safety feature built into your Jazzy 1120. See figure 5.
When the batteries and the motors are heavily strained (e.g., from excessive loads), the main circuit breaker
trips to prevent damage to the motors and the electronics. If the circuit trips, allow your Jazzy to “rest” for
approximately one minute. Next, push the circuit breaker button, turn on the joystick controller, and continue
normal operation. If the main circuit breaker continues to trip repeatedly, contact your authorized Pride pro-
vider.
n Lighting Harness Connector (Optional): This is where the optional lighting harness connects to the control-
ler. See figure 6.
n Controller Harness Connectors: This is where the joystick connects to the motors, batteries, and charger.
If your Jazzy is equipped with a Remote Plus or Europa controller, there is only one connector on the tray. If
your Jazzy is equipped with a Pilot controller, there are two connectors on the tray. See figures 2c, 3, and 4.
n Power Seat Connector: This is for the optional power seat switch. See figure 2c.
STANDARD HEADLIGHT/
TAILLIGHT CONNECTOR
Figure 5. Main Circuit Breaker
18
T H E
MAIN CIRCUIT BREAKER
www.pridemobility.com
J A Z Z Y
FULL LIGHTING HARNESS CONNECTOR
Figure 6. Full Lighting Harness Connector
1 1 2 0
Jazzy 1120/RevE/Feb03