Pride Jazzy 1120 Owner's Manual page 25

V I . C O M F O R T
ARMREST ANGLE
You can adjust the armrest angle to fit your specific needs.
To change the armrest angle:
1. Lift the armrest straight up so that it is perpendicular to the floor.
2. Use a 7/16-in. wrench to loosen the jam nut. See figure 18.
3. Use a 5/32-in. hex key to loosen the adjusting screw.
4. Turn the screw clockwise to lower the front of the armrest, or turn
the screw counterclockwise to raise the front of the armrest.
5. Lock the adjusting screw into place by tightening the jam nut.
ARMREST HEIGHT (OPTIONAL)
Your Jazzy may be equipped with height-adjustable armrests.
To change the armrest height:
1. Loosen the setscrew located underneath the armrest using a 3/16-
in. hex wrench.
2. Remove the ball detent pin from the armrest.
3. Move the armrest up or down to the desired height.
4. Align the holes and reinsert the ball detent pin.
5. Retighten the setscrew.
JOYSTICK EXTENSION
The joystick control can easily slide out away from the armrest, or in
toward the armrest.
To extend the joystick:
1. Use a 3/16-in. hex wrench to loosen the setscrew. See figure 19.
2. Slide the joystick mounting bracket into or out of the armrest to the
desired position.
3. Tighten the setscrew by turning it clockwise.
SWING-AWAY JOYSTICK
Your Jazzy may be equipped with a swing-away joystick. This option
enables you to move the joystick from the front of the armrest to the
side of the armrest, without disconnecting it. See figures 20 and 21.
The joystick can be mounted to the left or right side of your Jazzy.
Contact your authorized Pride provider.
Jazzy 1120/RevE/Feb03
A D J U S T M E N T S
Figure 19. Joystick Extension
Figure 20. Swing-Away Joystick
(Forward Position)
Figure 21. Swing-Away Joystick
(Retracted Position)
www.pridemobility.com
LOOSEN THIS
SETSCREW TO
ADJUST
JOYSTICK
25