Manufacturer's Notes; Fcc Class A Compliance Statement - Fujitsu SCENICVIEW XP70 User Manual

SCENICVIEW XP70

Manufacturer's notes

Energy Star
The EPA estimates that computer equipment uses 5% percent of all business electricity and that this
is growing rapidly. If all desktop computers and peripherals enter a low-power mode when not in use,
the overall savings in electricity could amount to $ 2 thousand million annually. These savings could
also prevent the emission of 20 million tons of carbon dioxide into the atmosphere - the equivalent of
5 million automobiles.
As an Energy Star Partner, Fujitsu Siemens Computers GmbH has determined that this product
meets the Energy Star guidelines for energy efficiency.
CE marking
The shipped version of this device complies with the requirements of the EEC directives
89/336/EEC "Electromagnetic compatibility" and 73/23/EEC "Low voltage directive".
Warning!
!
This is Class A device. This equipment may cause radio interference in a residential
installation. In this case the user is encouraged to perform appropriate measures to correct
the interference.

FCC Class A Compliance Statement

The following statement applies to the products covered in this manual, unless otherwise specified
herein. The statement for other products will appear in the accompanying documentation.
NOTE:
This equipment has been tested and found to comply with the limits for a "Class A" digital device,
pursuant to Part 15 of the FCC rules and meets all requirements of the Canadian Interference-
Causing Equipment Regulations. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in strict accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
● Reorient or relocate the receiving antenna.
● Increase the separation between equipment and the receiver.
● Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
● Consult the dealer or an experienced radio/TV technician for help.
4 - English
The Fujitsu Siemens projector SCENICVIEW XP70 is designed to
conserve electricity by dropping to less than 11 W when it goes into
standby, suspend and OFF mode. With this new power management the
SCENICVIEW XP70 qualifies for the U.S. Environmental Protection
Agency's (EPA) Energy Star Computers award.
A26361-K954-Z100-1-5E19, edition 5