Switching The Projector On And Off - Fujitsu SCENICVIEW XP70 User Manual

Switching the projector on and off

Always turn the system units on in the following order.
● Switch the projector on.
● Switch the computer on.
► Turn the projector on with the power switch on the projector's operating panel (2) or on the
remote control (3).
The power indicator (1) signals to current operating condition as follows:
Stage
ON
OFF
Cool-down phase
Standby mode
i
The projector can be turned on only when it is in standby mode.
Even when the projector is turned off, it is still connected to the power. Remove the plug
!
from the mains outlet so that the system is totally disconnected from the mains voltage.
Remove the power plug only when the power indicated glows orange!
A26361-K954-Z100-1-5E19, edition 5
Power Function
indicator
lights green The projector starts up and operates. If
there is no signal, the preset logo is
displayed.
blinks slowly The projector is shut down, the
orange projector lamp is shut off (no image)
and is being cooled, the fan runs.
The projector cannot be turned on in
this stage!
glows orange The projector is in standby mode.
SCENICVIEW XP70
Power
consumption
< 175 W
< 11 W
< 11 W
English - 11