Cleaning Notes; Transport Notes - Fujitsu SCENICVIEW XP70 User Manual

● If you do not use the projector for a longer period of time, shut off the power source completely
(for example, by switching off a power bar) or disconnect the power cable from the projector.
● Use only the included power cable or a cable that is approved for your country.
● Lay all cables so that nobody can stand on them or trip over them. When attaching the device,
observe the relevant notes in the "Preparing for use chapter.
● No data transfer cables should be connected or disconnected during a thunderstorm.
● Make sure that no objects (e.g. jewellery chains, paper clips, etc.) or liquids get inside the
device (danger of electric shock, short circuit).
● If you notice an unusual smell, see smoke, and in emergencies (e.g. damaged casing,
components or cables, penetration of liquids or foreign matter), switch the unit off, disconnect
the power plug and contact your sales outlet or our customer service center.
● Only qualified technicians should repair the device. Unauthorised opening and incorrect repair
may greatly endanger the user (electric shock, fire risk).
● Do not look into the lens while the projector is running.
● To avoid injuries, always place the projector on a solid surface and use only the approved
cover mount.
● You may set only those resolutions and refresh rates specified in the "Technical data" chapter.
● Allow the projector to cool down before you pack it up or transport it.
● Keep this operating manual together with your device. If you pass on the device to third parties,
you should include this manual.

Cleaning notes

● Always pull out the power plug before you clean the projector.
● Do not clean any interior parts yourself, leave this job to a service technician.
● Do not use any cleaning agents that contain abrasives or may corrode colours.
● Ensure that no liquid will run into the system.
● Regularly clean the projector's air vents to maintain sufficient cooling air flow.
● The surface of the lens is sensitive to pressure and scratches. Clean it only using a soft, slightly
moistened cloth.
Wipe the projector casing with a dry cloth. If the monitor is particularly dirty, use a cloth which has
been moistened in mild domestic detergent and then carefully wrung out.

Transport notes

● Allow the projector to cool down before you pack it up or transport it.
● Transport the projector with care and only in its original packaging or another corresponding
packaging fit to protect it against knocks and jolts.
● Above all, never drop the projector.
A26361-K954-Z100-1-5E19, edition 5
SCENICVIEW XP70
English - 3