Eclipse CD7200 mkII Reference Manual page 121

8
Press a button from [1] to [5] for
more than two seconds to preset a
setting value.
The preset value is overwritten by the
value set using the above steps.
The time alignment and crossover
adjustments will also be stored at this
time.
Selecting an equalizer mode
from memory
Press a preset button to select the equalizer
mode set in memory on the button. The buttons
that set equalizer modes in the memory are
called preset buttons.
Select a button from [1] to [5] and
press it for less than one second
while the PEQ setting mode is
activated.
The preset pattern stored in the
memory will be retrieved.
mATTENTION
When the preset value is changed, the display
shows as follows:
P
L
1 to 5 (Preset ch No.)
How to operate the Sound Adjustment Mode
Measuring/displaying frequency
characteristics
Frequency characteristics inside the vehicle can
be measured and shown on the display. The
measurement result can be referred to when
adjusting the parametric equalizer. This result is
also necessary to automatically correct the
parametric equalizer setting using E-iSERV
Audio Customize.
mATTENTION
• Adjust time alignment (refer to page 74) and
crossover (refer to page 75) before
measuring frequency characteristics.
• When measuring frequency characteristics,
CSII and Loudness settings are
automatically cancelled.
• Close all doors and windows while
measurement is in progress.
~CAUTION
In order to make the measurement of •
frequency characteristics easier, slight
errors may occur in the measurement data
under some circumstances when this
function is used. In addition, it is not
equivalent to the precise measurements
that can be made by specialist measuring
devices.
73