Care And Maintenance; General Guidelines - Pride Mobility JET 1HD Owner's Manual

X . C A R E
ROUTINE MAINTENANCE
The Jet is a sophisticated power chair. Like any motorized vehicle, it requires routine maintenance checks. You can
perform some of these checks, but others require assistance from your authorized Pride provider. Preventive
maintenance is very important. If you follow the maintenance checks in this section as scheduled, you can help
ensure that your Jet gives you years of trouble-free operation. If you have any doubt as to your Jet’s care or
operation, contact your authorized Pride provider.
The Jet, like most electrical equipment, is susceptible to damage from the elements. Avoid damp
areas of any kind. Direct exposure to water or dampness could cause the power chair to malfunc-
tion electronically and mechanically. Water can cause electrical components to corrode and the
chair’s frame to rust.
Should your Jet come in contact with water:
1. Dry your Jet as much as possible with a dry towel.
2. Allow your Jet to sit in a warm dry place for twelve hours to allow unseen water to evaporate.
3. Check the joystick operation and the brakes before using your Jet again.
4. If any inconsistencies are found, take your Jet to your authorized Pride provider.
Temperature
Some of the parts of your Jet are susceptible to extreme changes in temperature. Always keep your Jet between
the temperatures of 18° F and 122° F.
n In extremely cold temperatures the batteries may freeze. The specific temperature at which they will freeze
depends on a number of factors, such as battery charge, usage, and composition of the batteries (e.g., sealed
lead-acid or gel cell).
n Temperatures above 122° F may cause your Jet to operate at a reduced speed. This is a safety feature built
into the controller that helps prevent damage to the motor and other electrical components. See VIII. “Opera-
tion.”

General Guidelines

n Avoid knocking or bumping the controller, especially the joystick.
n Avoid prolonged exposure of your Jet to extreme conditions, such as heat, cold, or moisture.
n Keep the controller clean.
n Check all controller connectors on the electronics tray to ensure that they are all tight and secured properly.
Also check the charger inhibit connector.
n When the battery gauge is completely lit, the batteries are fully charged, and the controller and the electrical
system are OK.
n If two red bars on the battery gauge are blinking slowly, the batteries are low and need to be charged, but the
controller and the electrical system are OK.
n If the battery gauge is blinking rapidly, the controller has detected a fault in either its own circuits or in your Jet’s
circuits. See VIII. “Operation.”
WARNING! Make sure your tires are inflated to 30-35 psi. Do not underinflate or overinflate your
tires. Low pressure may result in loss of control, and overinflated tires may burst. Serious personal
injury may result. Overinflating tires can cause them to explode and can result in personal injury.
WARNING! Do not use a high pressure hose to inflate your tires.
Jet1 HD/Rev H/Feb03
A N D M A I N T E N A N C E
www.pridemobility.com 41