Operation; Battery Gauge - Pride Mobility JET 1HD Owner's Manual

The electronic controller is what you use to operate your power chair. It takes the battery voltage and sends it to
the appropriate system. For example, when the electronic controller power is on and you move the joystick, you
send battery voltage to the motors to move your power chair. The electronic controller also enables you to monitor
battery charge, electronic controller functions, and the condition of your electrical system. Also, it may be used to
control some optional systems such as power elevating seats and lights.
Pilot Controller
The Pilot electronic controller is an integral electronic controller. All of the electronics necessary to operate the
power chair are contained in one module. See figure 24a.
The Pilot consists of:
1. joystick
2. on/off button

3. battery gauge

4. speed control
5. charger socket
6. 9-pin Beau connector
7. 3-pin charger inhibit connector
Typically, the Pilot is mounted to one of the
armrests and is connected to the motors, batteries,
and the onboard charger at the electronics tray.
Joystick
The joystick controls the direction and speed of your power chair. When you move the joystick from the center
(neutral) position, the electromagnetic brakes release and allow your power chair to move. The further you push
the joystick from its center position, the faster your power chair moves. When you release the joystick and allow
it to return to the center position, you engage the electromagnetic brakes. This causes your power chair to decel-
erate and come to a complete stop.
WARNING! If your power chair begins to move in an unexpected manner, immediately release the
joystick. Unless the joystick is damaged, this action should stop your power chair.
On/Off button
This is a green button located in front of the joystick. It turns Pilot on and off.
WARNING! Unless faced with an emergency situation, do not use the on/off push button to stop the
chair. This will cause the power chair to stop abruptly.
WARNING! Always turn the power off when you are stationary to prevent unexpected movement.
Battery Gauge
The battery gauge is located immediately in front of the joystick. This is a 10-segment illuminated display that
indicates that the Pilot is turned on and also gives the battery status, the Pilot status, and the electrical system status.
Jet1 HD/Rev H/Feb03
V I I I . O P E R A T I O N
www.pridemobility.com
4
7
1
6
5
Fig. 24a. Pilot Controller
2
3
29