Pride Mobility JET 1HD Owner's Manual page 19

Electronics Tray
The electronics tray is located on the back of the power base. See figure 4. The ammeter, the onboard charger AC
power cord receptacle, the main circuit breaker, the controller connector, and the charger inhibit connector are all
located on the electronics tray.
Ammeter: The ammeter displays the charger’s current output in amps. See IX. “Batteries and Charging.”
Main Circuit Breaker: The main circuit breaker is a safety feature built into your Jet. When the batteries and the
motors are heavily strained (e.g., from excessive loads), the main circuit breaker trips to prevent damage to the
motors and the electronics. If the circuit trips, allow your Jet to “rest” for approximately one minute. Next, push in
the circuit breaker button, turn on the controller, and continue normal operation. If the main circuit breaker contin-
ues to trip repeatedly, contact your authorized Pride provider.
Onboard Battery Charger AC Power Cord Receptacle: This is where the AC power cord plugs into the
onboard charger.
Controller Connector: This is where the controller connects to the power base.
Charger Inhibit Connector: Your power chair is equipped with a charger inhibit connector. The charger inhibit
enables the onboard charger to disable the controller during charging. The charger inhibit connector is coded with
colorted dots. The dots are positioned so that you can align the flat side of the male connector with the flat side of
the female connector before making the connection.
CAUTION! Failure to properly align the connectors can result in damage to the controller, the
charger harness, and the connectors.
ONBOARD BATTERY
CHARGER AC
POWER CORD
RECEPTACLE
Jet1 HD/Rev H/Feb03
I V . T H E
AMMETER
Figure 4. Electronics Tray
www.pridemobility.com
J E T 1
MAIN CIRCUIT BREAKER
H D
CONTROLLER CONNECTOR
CHARGER
INHIBIT
CONNECTOR
19