Advertisement
ST1000SPEX on another motherboard.
Computer failed to start after inserting Gigabit Ethernet PCI
Express Card.
Turn off the computer, remove the ST1000SPEX, and try to restart the
computer. If the computer starts successfully, it means that this card
has not been inserted into the PCI Express slot correctly. Please insert
the card firmly into the PCI Express slot or try another slot.
How to deal with an exclamation point icon on the Ethernet Host
controller.
1. Please shutdown your computer and move the card to another avail-
able slot, then re-install the ST1000SPEX drivers again.
2. This icon usually means that there is a resource conflict between
the ST1000SPEX and another card in your system. Please move the
card to another available slot and restart your computer. Windows will
then re-configure itself and re-assign resources. Check your device
manager again. If the exclamation point is still there, repeat the process
until it no longer appears.
The card is not operating at Gigabit Ethernet transfer speeds.
1. Please affirm your Ethernet environment supports Gigabit structure.
2. Please use CAT6 UTP/STP cable.
4
Advertisement
