General Settings; Http Settings - D-Link SecuriCam DCS-2100+ Manual

Using the DCS-2100+ with an Internet browser
(continued)
Configuration > Advanced > Network
Reset IP Address at next boot
Once the DCS-2100+ is configured, this box should be unchecked at all times.
If the box has been checked and the connection is lost, run IP Installer to find
the camera's IP address.

General Settings

IP address -
Subnet mask -
Default router -
Primary DNS -
Secondary DNS -

HTTP Settings

HTTP Port-
Necessary for network identification.
Used to determine if the destination is in the same
subnet. The default value is "255.255.255.0."
The router used to forward frames to destinations
in a different subnet. Invalid router settings may
cause the failure of transmissions to a different
subnet.
Primary domain name server that translates
names to IP addresses.
Secondary domain name server to backup the
primary one.
Can be set to other than the default port 80. When
the administrator changes the HTTP port of the
DCS-2100+ (which has an IP address of
192.168.0.100) from 80 to 8080, users must type
http://192.168.0.100:8080 in the Web browser
bar.
33