D-Link SecuriCam DCS-2100+ Manual page 27

Using & Configuring the DCS-2100+ with a
NAT Router (continued)
Follow these steps to configure your router's Virtual Server settings:
•
Click Enabled.
•
Enter a different name for each entry.
•
Enter your camera's local IP Address (e.g., 192.168.0.102 in
the example in step
•
Select Both under Protocol Type (TCP and UDP)
•
If you are using the default camera port settings, enter 80 into
the Public and Private Port section, click Apply.
•
Scheduling should be set to Always so that the camera images
can be accessed at any time.
Repeat the above steps adding ports 5001, 5002 and 5003 to both the
Public and Private Port sections. A check mark appearing before the
entry name will indicate that the ports are enabled.
Important: Some ISPs block access to port 80 and other commonly used
Internet ports to conserve bandwidth. Check with your ISP so that you can
open the appropriate ports accordingly. If your ISP does not pass traffic on port
80, you will need to change the port the camera uses from 80 to something
else, such as 800. Not all routers are the same, so refer to your user manual
for specific instructions on how to open ports.
Enter valid ports in the Virtual
Server
section of your router
on page 23) in the Private IP field.
192.168.0.102
27