Camera Configurations - D-Link SecuriCam DCS-2100+ Manual

Using IP surveillance Software (continued)
Monitor Program (continued)
The Admin Privilege
In the Monitor program, the admin has the right to access the DCS-2100+
Network Camera through this application software and change the local settings
as well. But the admin password for the software is not the same as the admin
password for the Internet camera. You can change the settings of each selected
Internet camera from the Monitor program only if you have the admin password
for the Internet camera.
If you have the admin privilege, you have the right to do the following tasks:
Run the configuration tool
Change the recording schedule
Change the local settings
Again, if you need to change the settings of the DCS-2100+, you must have
the administrator's password for the camera itself.

Camera Configurations

When you log in for the first time, you should configure this application software
to connect the DCS-2100+ in "Configuration Menu \ Camera Configurations",
shown in the figure below. You will need the admin (administrator) password of
the camera in order to run the configuration.
Once you click "Configuration Menu\Camera Configurations" for setting
each camera, all recording processes will be stopped indicated by a warning
window popped up in advance to keep you informed.
71