General Settings; Http Settings - D-Link SecuriCam DCS-5300 User Manual

Using the DCS-5300 with an Internet browser
(continued)
Configuration > Advanced > Network
Reset IP Address at next boot
Once the DCS-5300 is configured, this box should be unchecked at all times. If
the box has been checked and the connection is lost, either run IP Installer or
PING the IP Address of the camera from a command prompt to regain the
connection.

General Settings

IP address -
Subnet mask -
Default router -
Primary DNS -
Secondary DNS -

HTTP Settings

HTTP Port-
Necessary for network identification.
Used to determine if the destination is in the same
subnet. The default value is "255.255.255.0."
The router used to forward frames to destinations
in a different subnet. Invalid router settings may
cause the failure of transmissions to a different
subnet.
Primary domain name server that translates
names to IP addresses.
Secondary domain name server to backup the
primary one.
Can be set to other than the default port 80. When
the administrator changes the HTTP port of the
DCS-5300 (which has an IP address of
192.168.0.146) from 80 to 8080, users must type
http://192.168.0.100:8080 in the Web browser
bar.
33