Connecting An Hdmjtm Or Dvi Device To The Hdmi Input - Toshiba 22AV500U Owner's Manual

Chapter 2: Connecting your TV
Connecting an HOMITM or OVI
device to the HOMI input
The HDMI input on your TV receives digital audio and
uncompressed digital video from an HDMI source device,
or uncompressed digital video from a DVI (Digital Visual
Interface) source device.
This input is designed to accept HDCP (High-Bandwidth
Digital-Content Protection) program material in digital form
from EIA/CEA-861-D--compliant fll consumer electronic
devices (such as a set-top box or DVD player with HOM] or
DVI output).
The HDMI input can accept and display VGA, 480i (60Hz),
480p (60Hz), nop (60Hz), and 1080i (60Hz) signal formats.
For detailed signal specifications, see page 60.
Supported Audio format: Linear PCM, sampling rate 32/44.1/
48 kHz
Note: To connect
a
PC to the HOMI input, see page 19.
To connect an HOMI device, you will need:
• one HDMI cable (type A connector) per HDMI device
- For proper operation,
it
is recommended that you use an
HOMI cable with the HOMI Logo (HLlm.).
- To display an 1080i/60Hz signal format, you will need
a
Category 2 cable. Conventional HOMI/O VI cable may
not work properly
- HOMI cable transfers both video and audio. Separate
analog audio cables are not required (see illustration).
- See "Setting the HOMITM audio mode"
(1rF
page 32).
TV back panel
~ 7H~m~J. ~
d·;w.,
fh=?t
2 1 AUDIO AGB
HDMIIN SER' I ICE PC IN
HOMI device
VIDEO I
AUO~
[O~ ~~~
[O~ ~i+
L R
To view the HOMI device video:
Select the HDMI I, or HDMI 2 video input source on the
TV.
*
*
To select the video input source, press INPUT on the remote control
(1rF page 21). To program the TV remote control to operate other
devices, see Chapter 3.
To connect a OVI device, you will need:
• one HDMI-to-DVI adapter cable (HDMI type A connector)
per DVI device
- For proper operation, the length of an HOMI-to-OVI
adapter cable should not exceed 9.8 ft (3m). The
recommended length is 6.6 ft (2m).
• one pair of standard analog audio cables per DVI device
- An HOMI-to-OVI adapter cable transfers video only
Separate analog audio cables are required (see
illustration).
- See "Setting the HOMITM audio mode"
(1rF
page 32).
TV back panel
~ Hi:JmIJ ~
d
~ ~
!
le:;b
fkiJt
2
fkiJt
1 AUDIO
~-
HOMIIN SEJI'fCE PC IN
=
OVI device
Note: To ensure that the HOMI or OVI device is reset properly,
it is recommended that you follow these procedures:
• When turning on your electronic components, turn on the
TV first, and then the HOMI or OVI device.
• When turning off your electronic components, turn off the
HDMI or DVI device first, and then the TV.
[1] EINCEA-861-D compliance covers the transmission of
I
uncompressed digital video with high-bandwidth digital content
protection, which is being standardized for reception of high-
definition video signals. Because this is an evolving technology, it
is possible that some devices may not operate properly with the
TV
HDMI, the HDMIIogo and High-Definition Multimedia Interface are
I
trademarks or registered trademarks of HOMI Licensing LLC.