Steamfast SF-420 User Manual page 8

ATTACHING LINT REMOVER
AND FABRIC BRUSH
1. Make sure Lighted On/Off Switch is set
to "Off" position, and that unit is not
emitting any steam. Do not try to
connect Lint Remover or Fabric Brush
while unit is emitting steam, as this can
cause burns and injury.
2. Align two pegs on back of Lint Remover
or Fabric Brush with corresponding
holes on face of Steam Nozzle. Use
care to properly align attachment as
shown (FIGURE 5), so as not to cover
up steam holes on nozzle face.
3. Press Lint Remover or Fabric Brush
firmly onto Steam Nozzle, until it fits
securely in place.
CAUTION: To prevent steam from causing bodily injury or damage to
surfaces, always hang the Steam Nozzle on the Steam Nozzle Holder when not
in use.
Do not lay the Steam Hose on the floor as condensation may occur, causing
unwanted water droplets in the steam.
Do not pull on the Steam Hose with excessive force as this may damage it,
resulting in a steam leak.
Your new SF-420 Fabric Steamer is now fully assembled and ready for use. Please
continue reading this manual for instructions on using the Fabric Steamer, directions
for cleaning and storage, and troubleshooting tips.
8
A
SSEMBLING THE
Top Innovations, Inc.
F S
ABRIC TEAMER
FIGURE 5