Table of Contents
Advertisement
PROBLEM
Unit fails to steam. Lighted
On/Off Switch does not
illuminate.
Unit fails to steam. Lighted
On/Off Switch does
illuminate.
Excessive gurgling in Steam
Hose and Steam Nozzle /
water drips from Steam
Nozzle.
Steam output is weak or
intermittent.
For problems with your Fabric Steamer, please refer to the troubleshooting
solutions located above. Additional inquiries should be directed to our Customer
Support services through our Web site, www.steamfast.com, on the Service Request
Web page.
If you do not have internet access, you may also contact our Customer Support
department by telephone, at (800) 711-6617 or (816) 584-9700.
NOTE: In order for our customer service representatives to help you as
quickly and efficiently as possible, please have the following information ready
before calling:
- Purchase information (where and when you purchased this product)
- Product Serial Number
T
ROUBLESHOOTING
POSSIBLE CAUSE
Unit is not plugged in.
Household Circuit Breaker /
Ground Fault Interrupter has
tripped or blown a fuse.
Water Tank is empty.
Mineral build-up in unit.
Condensation in Steam Hose.
Mineral build-up in unit.
CUSTOMER SUPPORT
Top Innovations, Inc.
& C
USTOMER
SOLUTION
Plug into electrical
outlet.
Reset Circuit Breaker /
Ground Fault Interrupter, or
replace fuse. If you need
assistance, contact a licensed
electrician.
Refill Water Tank using
procedures on page 9 of this
manual.
Follow Removing Mineral
Build-Up procedure on page
12 of this manual.
Some gurgling is a natural
effect of steaming process.
For excessive gurgling or
dripping water, point Steam
Nozzle towards ground and
shake to remove excess water
droplets.
Follow Removing Mineral
Build-Up procedure on page
12 of this manual.
S
UPPORT
13
Advertisement
Table of Contents
Need help?
Do you have a question about the SF-420 and is the answer not in the manual?
Questions and answers