KitchenAid 30" Installation Instructions And Use & Care Manual page 7

Cabinet Dimensions
Interior-mounted blower motor model
A= ¹⁄₂" (12.7 mm)
minimum
21⁵⁄₁₆"
(54.1 cm)
Cutouts are
for 3¹⁄₄" x 10"
(8.3 x 25.4 cm)
rectangular or 6"
(15.2 cm) round
vent system.
Locate power
supply junction
box at lower
left hand
rear corner
of the cabinet.
NOTES:
See cooktop manufacturer's instructions for cooktop cutout
depth and width.
Use dimensions for vent system cutout location that applies
to your installation.
Interior-mounted blower systems connect with 3¹⁄₄" x 10"
(8.3 x 25.4 cm) rectangular or 6" (15.2 cm) round vent
system. The cutout locations for this vent system will
depend on your specific installation.
Countertop Cutout Dimensions
IMPORTANT: Countertops with a bull-nosed front edge are not recommended for these installations.
Some models require a countertop deeper than 25" (63.5 cm); see the following Countertop Cutout Dimensions Chart.
To avoid mistakes, it is recommended that the cooktop and vent cutouts be drawn on the countertop before making any cutouts.
See Cooktop Installation Instructions for complete cutout dimensions, location dimensions and installation details.
A. Downdraft vent
B. Cooktop
C. Measurement of cooktop rear overhang.
10" (25.4 cm)
21⁵⁄₁₆"
(54.1 cm)
Centerline of cooktop cutout
B
A
D. D = Measurement of cooktop rear overhang
(C) + 1
¹³⁄₁₆
E. 1 " (46.2 mm)
F. ½" (12.7 mm) minimum
Exterior-mounted blower motor model
¹⁄₂" (12.7 mm)
minimum
Locate power
supply junction
box at lower
left hand
rear corner
of the cabinet.
NOTES:
See cooktop manufacturer's instructions for cooktop cutout
depth and width.
Exterior-mounted blower systems connect with 10" (25.4 cm)
round vent. The cutout locations for this vent system will
depend upon your specific installation.
D
E
F
C
G
I
¹³⁄₁₆
" [46.2 mm] (E)
H
G. ¼" (6.4 mm) minimum
H. Countertop and backsplash
I. ½" (12.7 mm) minimum
7